2005 Ford Pickup F250 Super Duty Installing New D-Ring Seals On...
download Installation All vehicles NOTE: CAUTION: Install new D-ring seals on the crankcase-to-head tube. It requires several hours after installation for the D-ring seals to relax back to their...
View Article2005-2009 Grand Cherokee Hard To Fill With Fuel Or Fuel Nozzle Shuts Off...
download Customer may report that the vehicle is hard to fill with fuel or that the fuel pump nozzle shuts off repeatedly while trying to fill vehicle. This customer complaint can occur due to a number...
View Article2006 Ford Five Hundred SE Upper Intake Manifold Removal
download All vehicles 1. Drain the cooling system. For additional information, refer to DRAINING . 2. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION...
View Article2004 Mazda 3 L4 Cold Air Intake Installation Guide
download Removal of Factory Intake 1. 2. Pull upwards to remove the engine cover. Unclip the battery cover and remove, then disconnect the negative battery cable. Disengage the plastic rivet. Slide the...
View Article2002-2005 Subaru Impreza WRX/STI Cold Air Intake Installation Guide
download Removal of Factory Intake 1. 2. Turn the ignition OFF and disconnect the vehicle’s negative battery cable. Loosen and remove the two bolts that secure the air inlet duct to the radiator core...
View Article2000 Jeep Grand Cherokee Heater Core: Service and Repair
download REMOVAL 1. Remove the heater-A/C housing from the vehicle. See: Housing Assembly HVAC/Service and Repair 2. Remove the foam gasket surrounding the core tubes. NOTE: Notice the orientation of...
View Article2004 Ford F-Super Duty 250-550 Fuel Injectors Removal Installation
download All vehicles 1. Remove the valve cover. For additional information, refer to Section 303-01C. 2. Disconnect the fuel injector electrical connector. Two-piece head tube 3. NOTE: Some engines...
View Article2009 – 2010 Nissan cube FUEL FILLER RECIRCULATION TUBE
download SERVICE PROCEDURE 1. Raise the vehicle off the ground with a vehicle hoist. 2. Remove the right rear wheel. 3. Remove 2 bolts from the fuel filler tube bracket. 4. Remove the plastic cover (4...
View Article2000 Hyundai Elantra GLS Wagon Power Steering Line/Hose: Service and Repair...
download While installing the tube and hose assembly, be sure to align white marks on each fitting. Pressure Hose and Tube 1. Remove the air intake hose assembly. 2. Detach the pressure hose mounting...
View ArticleInstallation Instructions for TRD’s 3.4-liter V6 Supercharger Kit 1997-2000...
download Removal of Stock Intake Manifold (figure 1) 1. Disconnect the battery ground cable. 2. With tape or a permanent marker, mark the forward edge of the power steering and the air conditioning...
View Article
